Filter
Top Products
Connect the supplied speaker system using the supplied speaker cords by matching the polarities and colours of the
terminals.
NOTE: Please refer to “Setup Menu” for parameter setup.
HOW TO CONNECT?
Your speaker connection is made easy by matching the color coded speaker terminal to the color coded terminals on
the back of the HT-180.
Front speaker (R)
Center speaker
Front speaker (L)
• Connect front speaker with SPEAKER FRONT R and SPEAKER FRONT L.
• Connect rear speaker with SPEAKER REAR R and SPEAKER REAR L.
• Connect center speaker to SPEAKER CENTER.
•Connect subwoofer to SPEAKER WOOFER.
Notice for Speakers:
1.Short-circuiting of the speakers may damage the system. To prevent this, be sure to follow these precautions
when connecting the speakers. Make sure the bare wire of each speaker cord does not touch another speaker
terminal or the bare wire of another speaker cord.
• Do not connect audio outputs of the same speaker or those between the speakers, that may cause short
circuit.
• The examples of bad conditions of the speaker cord: Exposed end speaker cord is touching another speaker
terminal; exposed end cords are touching each other due to sloppy removal of insulation.
• After connecting all the equipments, speakers and AC power cord (mains lead), output a test tone to check
that all the speakers are connected correctly.
2. Please make sure the connections between speakers and the equipment are correct.
3. If you use front speakers with maximum input rating, adjust the volume carefully to avoid excessive output on
the speakers.
Rear speaker (R)
Subwoofer
Rear speaker (L)
To obtain the best possible surround sound, first specify the distance of the speakers from your listening position,
then set the balance and level. Use the test tone to adjust the speaker volumes to the same level.When you test
the speakers with “TEST TONE”, subwoofer will not respond.
You may adjust the speaker parameters using Speaker Setup in the setup menu.
NOTES:
• Depending on the settings of other speakers, the subwoofer may output excessive sound.
• If the distances of the speakers are not equal, adjust the speaker with shortest distance to the listener.
• According to the speakers, you may set delay value of the speaker via the “Speaker Setup”.
SPECIFYING THE SPEAKER PARAMETERS
A P E X D I G I T A LH T - 1 8 0
15
Speaker System Hookup