Alpine DVA-5205E CD Player User Manual


 
37
SET UP
SET UP
DVD
CD
Set to “DVD” when connected to the CVA-
1005E/IVA-C800E.
Operations can be performed using the CVA-
1005E/IVA-C800E’s main menu screen.
For details, refer to the operating instructions of
the CVA-1005E/IVA-C800E.
“DVD” is selected upon shipment from the
factory.
Set to “CD” when connected to an Ai-NET
product (head unit) other than the CVA-1005E/
IVA-C800E.
Operations can be performed from the head
unit.
For details, refer to “Operating from the head
unit” (page 56).
Notes:
Press “RTN” to return to the previous screen.
If the Ai-NET setting is “CD” when used with the
CVA-1005E/IVA-C800E, operation from the main
menu screen is not possible.
If the Ai-NET setting is “DVD” when used with any
Ai-NET compatible head unit other than the CVA-
1005E/IVA-C800E, volume is the only operation
possible
from the head unit.
To call the DVD video by using the CVA-1000E,
switch the mode to “AUX” with the V. SEL button
on the CVA-1000E.
When the Ai-NET setting is “CD”, the operable
functions and displays may differ depending on
the Ai-NET compatible head unit connected.
Press “SET” for at least
2 seconds.
The settings are stored
and the set up mode is
canceled.
Turn off the vehicle’s ignition, then turn
it on again.
Notes:
Cases in which DVDs cannot be played on the
CVA-1005E/IVA-C800E side
– When “DVD” is not displayed on the CVA-1005E/
IVA-C800E side menu screen
– When DVDs cannot be played even when AUX1
is selected
This is because the DVA-5205E’s Ai-NET setting is
set to “CD”.
Use the procedure described below to change the
setting.
1.Remove the disc from the DVA-5205E.
2.Turn on the power of the DVA-5205E and CVA-
1005E/IVA-C800E.
Also start up the CVA-1005E/IVA-C800E monitor.
3.Press the CVA-1005E/IVA-C800E SOURCE
switch and select “CD” from the menu.
4.Press the SOURCE switch, then select “V.SEL”
from the menu.
5.In the V.SEL mode, select “AUX1”. This displays
the DVA-5205E screen.
6.On the DVA-5205E, set the Ai-NET setting to
“DVD”. Refer to “Changing the Ai-NET settings”
(pages 36 and 37).
7.Turn the car’s ignition switch off, then turn it back
on.
Custom setting – Changing the Ai-NET settings
Displays the setting contents.