Filter
Top Products
32
SET UP
Changing the digital
output setting
Use the following procedure to set the
audio signal output from the DVA-5205E.
Changing the digital output setting
Select “DIGITAL OUT” under
“Changing the default settings
(SET UP)” on page 24.
Use the “Joystick” to make the
selection, then press “ENT”.
AUTO
LPCM
The digital output is switched automatically
according to the type of audio signals being
played.
Be sure to select “AUTO” when you want to
connect a digital audio processor and play
Dolby Digital audio. “AUTO” is selected upon
shipment from the factory.
The audio signals recorded on the disc are
converted into 48 kHz/16 bit (for DVDs) or 44.1
kHz (for video CDs and CDs) linear PCM audio
signals for output.