Filter
Top Products
En
ENGLISH
17
PROGRAMMED EDIT
RECORDING
24,5
FUNCTION
f,g
8
3,7
wREC/REC MUTE
DOLBY NR
JOG MODE
DOLBY NR
VOLUME/
MULTI JOG
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
NOTE
• The programmed edit recording will not start from a point
halfway in the tape. The tape must be recorded from the
beginning of either side.
• You can record up to 30 tracks by programmed edit function.
• You can set up to 30th track numbers by programmed edit
function.
1
Load the tape, and turn Dolby NR on or off using
DOLBY NR on the main unit, SHIFT and DOLBY
NR on the remote control, or JOG MODE and
VOLUME/MULTI JOG on the main unit. (See page
11, "PLAYING BACK A TAPE" for details.)
Load the tape with the side to be recorded on first facing
upward.
2
Press CD on the remote control (or press
FUNCTION on the main unit repeatedly) so that
"CD" appears, and load the disc.
3
Press EDIT repeatedly while pressing SHIFT on
the remote control until "EDIT" lights up and
"PRGM" flashes on the display.
4
Press the numbered buttons on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
• f and g are also available to designate the tape length.
5
Press the numbered buttons to program a track.
Example: To select the 10th track, press the numbered buttons
+10 and 0.
6
Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7
Press EDIT repeatedly while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
After confirming "B" on the display, repeat step 5.
8
Press w REC/REC MUTE to start recording.
The tape is rewound to the beginning of the side facing upward,
the lead segment is played through for 10 seconds, and
recording starts. When recording on the side facing upward
(side A) ends, recording on the opposite side (side B) starts.
To stop recording
Press s. Recording and CD play stop simultaneously.
To clear the edit program
Press s repeatedly in stop mode so that "EDIT" disappears on
the display.
To check the order of the programmed track numbers
Before recording, press EDIT while pressing SHIFT on the remote
control to select side A or B, and press g repeatedly.
To change the program of each side
Press EDIT while pressing SHIFT on the remote control to select
side A or B, and press s to clear the program of the selected
side. Then program tracks again.
NOTE
Recording is prohibited if the erasure prevention tab on either
side of the tape is broken off.
Tape side A (side
facing upward)
Selected track
TAPE RECORDING
Maximum
recording time for
side A
Total number of
programmed tracks
Tape side B
(opposite side)
Program number
Remaining time
of side A
Programmed
track numbers
Tape side
Track number
Program number