Filter
Top Products
MODE
SETTING THE CLOCK
1
2
3
CLOCK
b
Ikia=LQl”
Press the II button while the power is turned off,
or press the CLOCK button ‘while pressing
SHIFT button on the remote control.
The clock flashes on the display.
the
While the clock is displayed (for 4 seconds), press
the ++ or ~ button to designate the time.
Pressing the + button once will move the time back by 1
minute, and pressing the
➤F button once will advance the
time by 1 minute.
Holding these buttons down will vary the time in 10-minute
units.
To switch to the 24-hour standard, press the
■ button.
To restore the 12-hour standard, press the
■ button again.
If you do not
start setting the time within 4 seconds
The clock starts and becomes darker.
To set the clock, press the El button, or press the CLOCK
button while pressing the SHIFT button on the remote control.
The clock becomes brighter and the ++ and _ buttons
become available.
Press the 11 button.
The clock starts from 00 seconds.
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the system is
activated, and is not a malfunction.
The power economizing mode can be canceled. See
“ECONOMIZING POWER” for details.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The time is displayed for 4 seconds.
While the clock is displayed, you can reset it by pressing the
+ or - button. In this case, press the II button in the end.
SHiFT
ECONOMIZING POWER
This system allows you to regulate its power consumption by
displaying nothing on the display while the power is off. This is
called the power economizing mode.
Press the MODE button while pressing the SHIFT
button on the remote control with the power turned off.
Each press of this button changes the display status as follows:
@@ Power economizing mode
I @ Demo display (power economizing mode canceled)
~@ Clock display (power economizing mode canceled)
When the power economizing mode is set
“ECOMode” is displayed for 4 seconds, and everything on the
display will clear.
Only the red indicator to the right of the display window lights to
show that the power is supplied to the system.
Standby power consumption
If the power economizing mode is activated :2.5 W
m
If you press the <P button on the CD/tape unit (or the P button
on the remote control) with the power turned off, the power
economizing mode, if activated, will be canceled and the demo
display appears.
DIMMING THE DISPLAY
This system allows you to change the brightness of the display
window according to your preference.
Press the MODE button while pressing the SHIFT
button on the remote control with the power turned on.
Each press of this button changes the display status as follows:
r
@ Brighter display
@ Darker display
@ Demo display
If the power is turned off after changing the display brightness,
the display returns to the last status when the power is turned on
the next time.
ENGLISH 7