Filter
Top Products
LISTENING TO EXTERNAL
SOURCES
t
I
1-
a
AUX/MD
I
1 Press the AUX/MD button on the remote control
repeatedly until corresponding
source appears
on
the display.
To listen to the equipment connected to the AUX IN jack,
display “AUX.”
To listen to the equipment connected to the MD IN jack, display
“MD.”
2
Play the corresponding equipment connected.
To change the source name display corresponding to
the equipment connected to the AUX IN jack
For the equipment connected to the AUX IN jack, “AUX” is
displayed initially. It can be changed to “TV or ‘{VIDEO according
to the equipment actually connected to the jacks.
Call up “AUX on the display window and press the POWER button
while pressing the * button. Each press on the button changes
the display in the following order:
~ AUX
~ VIDEO ~ TV
m
CARE AND MAINTENANCE
Occasional care and maintenance of the system and the software
are needed to optimize the performance of your system.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution, Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the system.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths with
a commercially available head cleaning cassette.
Care of the system
● Do not give the system a strong shock i.e., drop or hit,
● Do not use the system close to a strong magnetic field such as
a television. Doing so may cause malfunctions.
Care of CDs
● When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
● After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
m
Care of tapes
● Store tapes in their cases after use.
● Do not leave tapes near magnets, motors, television sets, or
any source of magnetism. This will downgrade the sound quality
and cause noise.
● Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight.
The FUNCTION button on the CD/tape unit cannot be used to
select “MD” or “AUX.” Pressing the FUNCTION button only calls
up the external source currently selected.
ENGLISH
21