Filter
Top Products
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
Am!!vh
“CAUTION:TO REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.”
Explanation of Graphical Symbols:
The lightning flash with arrowhead symbol,
A
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
“dangerous voltage” within the product’s en-
closure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral
A
triangle is intended to alert the user to the
presence of important operating and mainte-
nance (servicing) instructions
in the literature
●
accompanying the appliance.
PRECAUTIONS
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions for
future reference. All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well as
the safety suggestions below.
Installation
1
2
3
4
5
6
Water and moisture – Do not use this unit near water, such as
near a bathtub, washbowl, swimming pool, or the like.
Heat – Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
H also should not be placed in temperatures less than 5°C
(41“F) or greater than 35-C (95”F).
Mounting surface – Place the unit on a flat, even surface.
Ventilation – The unit should be situated with adequate space
around itso that proper heat ventilation is assured. Allow 10cm
(4 in.) clearance from the rear and the top of the unit, and 5 cm
(2 in.) from the each side.
- Do not place the unit on a bed, rug, orsimilarsurface that may
block the ventilation openings.
-
Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
Objects and liquid entry -Take care that objects or liquids do
not get inside the unit through the ventilation openings.
Carts and stands – When placed or
mounted on a stand or cart, the unit
should be moved with care.
Quick stops, excessive force, and un-
@!l
L
even surfaces may cause the unit or
3
cart to overturn or fall.
AA*
7
8
Condensation – Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit forafew hours, then
try to operate again.
Wall orceilina mountina– The unit should not be mounted on
a wall or ceilin~, unless s~ecified in the Operating Instructions.
Electric Power
1
2
3
4
5
Power sources - Connect this unit only to power sources
specified in the Operating Instructions, and as marked on the
unit.
Polarization – As a safety feature, some units are equipped
with polarized AC power plugs which can only be inserted one
way into a power outlet. Ifit is difficult or impossible to insert the
AC power plug into an outlet, turn the plug over and try again.
If it still does not easily insert into the outlet, please call a
qualified service technician to service or replace the outlet. To
avoid defeating the safety feature of the polarized plug, do not
force it into a power outlet.
AC power cord
- When disconnecting the AC power cord, pull it out by the AC
power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this could
result in fire or shock.
- Power cords should be routed to avoid being severely bent,
pinched, or walked upon. Pay particular attention to the cord
from the unit to the power socket.
- Avoid overloading AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
Extension cord – To help prevent electric shock, do not use a
polarized AC power plug with an extension cord, receptacle, or
other outlet unless the polarized plug can be completely in-
serted to prevent exposure of the blades of the plug.
When not in use – Urmlua the AC Dower cord from the AC
outlet if the unit will not’be”used for &everal months or more.
When the cord isplugged in, asmall amount ofcurrent continues
to flow to the unit, even when the power is turned off.
Outdoor Antenna
1
2
Power lines – When connecting an outdoor antenna, make
sure it is located away from power lines.
Outdoor antenna aroundinct – Be sure the antenna system is
properly grounded-to provid; protection against une~pected
voltage surges or static electricity build-up. Article 810 of the
National Electrical Code, ANSVNFPA 70, provides information
on proper grounding of the mast, supporting structure, and the
lead-in wire to the antenna discharge unit, as well as the size of
the grounding unit, connection to grounding terminals, and
requirements for grounding terminals.
Antenna Grounding According to the National Electrical Code
~ ,ANTENN,4’LEAOINWIRE
ANTENNA DISCHARGE
(NEC SECTION 810-20)
ELECTRIC GROUNDING
SERVICE CONDUCTORS
EQUIPMENT
= (NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
,/ ELEcTRODE SYSTEM
(NEC ART 250 PART H)
NEC-NATIONAL ELECTRICAL
CODE
2 ENGLISH