Filter
Top Products
OPERATION
PLAYING BACK A TAPE
Load a ta~e.
<P
■
II
FUNCTION
t
LOADING A TAPE
0You can select a reverse mode to play back one or both sides.
@Use Type I (normal) , Type
II (high/Cr02) or Type IV (metal)
tapes for playback.
Press the TAPE button on the remote control (or
press the FUNCTION button on the CD/tape unit
repeatedly until “TAPE” appears on the display.)
Then insert a tape with the exposed side facing to
the right and push it gently until it is loaded
automatically inside the unit.
LJ
*
TO select a reverse mode
Press the TAPE button on the remote control.
Each time the button is pressed, the reverse mode changes.
I
Press the +- button on the CD/tape unit or the b
button on the remote control.
Playback side of the tape
The tape counter indicates the tape
running length. (It disappears when no
tape is inserted.)
D: The side facing upward is being played (forward).
Q: The side facing downward is being played (reverse).
About the level indicator
The above display automatically changes to the level indicator
after 4 seconds.
The level indicator shows an approximate playback sound level.
To stop play, press the
■ button.
To pause play, press the II button. To resume play, press again.
To change the playback side, press the +- button on the
CD/tape unit or the - button on the remote control in play or
pause mode.
To fast forward or rewind, press the
●+ or * button in stop
mode. Then press the
■ button to stop the tape.
To eject the loaded tape, press the 4 TAPE EJECT button in
stop mode.
To
start play when the power is off (Direct Play
Function)
Press the TAPE button on the remote control. The power is turned
on and play of the loaded tape begins.
To set the
tape counter to 0000
Press the ● button in stop mode.
The counter is also set to 0000 when the tape is ejected.
To play one side only, select 1.
To play from the side facing upward to the opposite side once
only, select 1>.
To play both sides repeatedly, select (Z).
ENGLISH 13