Filter
Top Products
PROGRAMMED EDIT RECORDING
44,-
■
●
REC
FUNCTION
c’)
rfl
],,,]
o
Cassette deck
●
0-9.+10
I
I
b
SHIFT
●REC/
REC MUTE
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
m
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
1
2
3
4
5
Load the tape into the cassette deck.
Load the tape with the side to be recorded on first facing
upward.
Press the CD button on the remote control, or
press repeatedly the FUNCTION button on the CD/
tape unit so that “CD” is displayed, and load the
disc.
Press the CD EDIT button repeatedly while
pressing the SHIFT button on the remote control
until “EDIT” lights up and “PRGM” flashes on the
display.
Press the numbered buttons to designate the tape
length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and O
buttons.
● The 4+ and - buttons are also available to designate
the tape length.
Tape side A (front side)
Maximum recording time for
side A
Press the numbered buttons to program a track.
Example:
To select the 10th track, press the numbered
buttons +10 and O.
6
7
8
Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Selected track
o
Program number
Total number of
Remaining time of side A
programmed tracks
Press the CD EDIT button while pressing the
SHIFT button on the remote control to select side
B and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (opposite side)
Press the ● REC button on the CD/tape unit
start recording.
to
To start recording with the remote control, press the ● REC/
REC MUTE button and within 2 seconds, press the * button.
The tape is rewound to the beginning of the side facing upward,
the lead segment is played through for 10 seconds, and
recording starts, When recording on the side facing upward
(A) ends, recording on the opposite side (B) starts.
To stop recording
Press the
■ button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the CD EDIT button while pressing the
SHIFT button on the remote control to select side A or B, and
press the - button repeatedly.
Programmed
Track number
track numbers
Program number
To change the program of each side
Press the CD EDIT button while pressing the SHIFT button on
the remote control to select side A or B, and press the
■ button
to clear the program of the selected side. Then program tracks
again.
To clear the edit program
Press the
■ button repeatedly so that “EDIT” disappears on the
display.
m
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENGLISH ~ 7