Filter
Top Products
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Press one of the function buttons to select a
source.
● If TUNER BAND is pressed, the band cannot be selected in
this step.
Press TIMER
repeatedly until @ appears on the
display.
When using the remote control, press TIMER while pressing
Sf-fll=-r.
Time and audio source name flash alternately.
o
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or H1.
Turning MULTI JOG changes both the hour and the minute.
+ or - is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated period.
The duration can be set between 5 and 240 minutes in 5-
minute steps.
- or - is also available instead of MULTI JOG.
5
6
7
Adjust the volume.
The source sound will play at the volume level set in this step
R
when the power is turned on by the timer.
J&
If the volume level is set to 21 or higher, however, it will
J#%,
-9
automatically be set to 20 when the power is turned on, .~. .~%
g%!
Prepare the source.
:$*$
To listen to a CD, load the disc to be played first on tray 1.
f$$$
To listen to a tape, insert the tape into deck 1 or 2.
8
a-y
To listen to the radio, tune in to a station.
6
Press POWER to turn off the power.
When the timer-on time is reached; the unit turns on and
begins play with the selected source,
m
You can change the source that was selected in step 1 by
pressing one of the function buttons before pressing ENTER or
II in step 3.
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that @ disappears.
To restore the timer standby mode, press again to display ~).
Using the unit while the timer is set
You can use the unit normally after setting the timer.
❑
Before turning off the power, ‘carry out step 5 and 6.
m
● Timer playback and timer recording will not begin unless the
power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press either TUNER BAND or VIDEO/AUX to select a source,
then press TIMER repeatedly until @ flashes on the display.
Within 6 seconds, carry out the steps of “SETTING THE TIMER
from step 3 and insert the tape to be recorded on into deck 2
after step 6.
● When the power-economizing mode (page 7) has been turned
on, the timer recording volume level will be O (minimum level).
c You cannot use the timer function to record from a CD or tape.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or II is pressed within 4 seconds after
step 4.
ENGLISH 19