Filter
Top Products
MANUAL TUNING
1
2
1
2
REPEATI
MONO
TUNER
Press the TUNER/BAND button repeatedly to
select the desired band.
FM — AM
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press
the l<< DOWN or WI UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE is displayed for 2 seconds.
During FM stereo reception, [IMDII is displayed.
To search for a station quickly (Auto Search)
Keep the 1<4 DOWN or >>1 UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the 1<< DOWN or P>l
\JP button.
aThe Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the REPEAT/MONO TUNER button on the remote control
so that “MONO appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press the button so that MONO
disappears.
PRESETTING STATIONS
1
2
1
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station. Use the
preset number to tune in to a preset station directly.
1
2
3
Press the TUNER/BAND button to select a band,
and press the l<< DOWN or >>1 UP button to
select a station.
Press the 11 SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequency
Preset number
Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
have already been stored for all the bands.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the
■ CLEAR button, and press the 11 SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
ENGLISH
8