Filter
Top Products
SETTING THE CLOCK
When the AC cord is connected for the
button flashes.
CLOCK
first time, the El SET
Set the time as follows while the power is off.
Press the 1MSET button.
The hour flashes.
Press the l<< DOWN or ›~1 UP button to
designate the hour,
Press the
II SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the 1<4 DOWN or WI UP button to
designate the minute.
Press the RI SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds,
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press
the 9 button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
[f the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
SIMPLE AUDIO ADJUSTMENT
BBE
GEQ
PHONES
VOLUME
Turn the VOLUME control on the main unit, or press the VOLUME
buttons on the remote control.
To change the Iefthight balance
Turn the BALANCE control.
BBE SYSTEM
The BBE system enhances the clarity of high-frequency sound.
It also enriches the KARAOKE function to make your voice sound
clear and pleasant.
Press the BBE button.
Each time it is pressed, the level changes, Select one of the
three levels, or the off position to suit your preference.
❑
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button,
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
m
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel theT-BASS system.
ENGLISH
6