Filter
Top Products
PRESETTING STATIONS
1
2
MONO
TUNER
1
2
Press the T!JNER/BAND button repeatedly to
select the desired band.
m
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the 1<4 DOWN or WI UP button to select
a station.
Each time the button is pressed, the frequency changes,
When astation is received, “TUNE is displayed for 2 seconds,
During FM stereo reception, (IK3D}Iis displayed.
To search for a station quickly (Auto Search)
Keep the 14< DOWN or
➤Fl UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the l<< DOWN or
➤>1
UP button.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the REPEAT/MONO TUNER button so that “MONO”
appears on the display.
Noise is reduced, although reception is monaural,
To restore stereo reception, press the button
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is
so that MONO
10 kHz/step, If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval,
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS) are cleared. The preset stations
have to be set again,
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station. Use the
preset number to tune into a preset station directly,
1
2
3
Press the TUNER/BAND button to select a band,
and press the l<< DOWN or ➤>1 UP button to
select a station.
Press the II SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequency
l—
Preset number
Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
have already been stored for all the bands.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the
■ CLEAR button, and press the II SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
ENGLISH 8