Filter
Top Products
SPECIFICATIONS
Main unit CX-NAV800
FM tuner section
Tuning range
Usable sensitivity (IHF)
Antenna terminals
Ahrltuner section
Tuning range
Usable sensitivity
Antenna
Amplifier section
Power output
Total harmonic distortion
Inputs
outputs
Cassette deck section
Track format
Frequency response
Signal-to-noise ratio
Recording system
Heads
87.5 MHz to 108 MHz
13,2 dBf
75 ohms (unbalanced)
530 kHz tO 1710 kHz (10 kHz
step)
531 kHz to 1602 kHz (9 kHz step)
350 pV/m
Loop antenna
Front
60 Watts per channel, Min.
RMS at 6 ohms, from 50 Hz to
20 kHz, with no more than I“A
Total Harmonic Distortion
Rear (Surround)
10 Watts per channel, Min. RMS
at 16 ohms, 1 kHz, with no more
than 1
Y. TotalHarmonic Distortion
Center
20 Watts, Min. RMS at 8 ohms,
1kHz,with nomore than 17.Total
Harmonic Distortion
0.1 ‘h (30 W, 1 kHz, 6 ohms, DIN
AUDIO/Front)
VIDEO/AUX: 230 mV (adjustable)
MIC 1, MIC 2: 1,7 mV (10 kohms)
SUPER WOOFER: 1.9 V
SPEAKERS: accept speakers of
6 ohms or more
SURROUND SPEAKERS:
accept speakers of 16 ohms or
more
CENTER SPEAKER:
accept speakers of 8 ohms or
more
PHONES (stereo jack): accepts
headphones of 32 ohms or more
4 tracks, 2 channels stereo
Cr02 tape: 50 Hz– 16000 Hz
Normal tape: 50 Hz– 15000 Hz
60 dB (Dolby B NRON, Cr02tape
peak level)
AC bias
Deck 1: Playback head x 1
Deck 2: Recording/playback/
erase head x 1
Compact disc player section
Laser Semiconductor laser (h= 780 nm)
D-A converter
1 bit dual
Signal-to-noise ratio
83 dB (1 kHz, OdB)
Harmonic distortion 0.057. (1 kHz, OdB)
Wow and flutter Unmeasurable
Cabinet type
Speakers
Impedance
Output sound pressure level
Dimensions (w x Hx
D)
Weight
General
Power requirements
Power consumption
Dimensions of main unit
(W XHXD)
Weight of main unit
Speaker system SX-NAV800
3 way, bass reflex (magnetic
shielded type)
Woofer:
140 mm
(55/8 in.) Cone type
Tweeter:
60 mm (23/8in.) cone type
Super tweeter:
20 mm
(’3/16 in.) Cet’amic type
6 ohms
87 dBIWlm
235 x 302 x 250 mm (93/,x 12 x
971ein.)
3.3 kg (7 Ibs 4
02,)
120 V AC, 60 I-Iz
lIOW
260 x 307 x 349 mm
(10’/4 x 12’/6x 133/4in.)
8.0 kg (17 Ibs 10 OZ.)
Specifications and external appearance are subject to change without
notice.
BLIESYSTEM
The word “BBE” and the “BBE symbol” are trademarks of BBE
Sound, Inc.
Under license from BBE Sound, Inc.
DOLBY NR/DOLBY PRO LOGIC
Manufactured under license from Dolby Laboratories Licensing
Corporation.
“DOLBY”, the double-D symbol LID and “PRO LOGIC” are
❑
trademarks of Dolby Laboratories Licensing Corporation.
COPYRIGHT
Please check the laws on copyright relating to recordings from
discs, radio or external tape for the country in which the machine
is being used.
NOTE
This equipment has been tested and found to comply with the
limits for a Class Bdigital device, pursuant to Part 15 of the FCC
Rules, These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations, However, there is no guarantee that interference will
not occur in a particular installation. Ifthis equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help,
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user’s
right or authority to operate this product.
ENGLISH 24