Filter
Top Products
PROGRAMMED EDIT RECORDING
3,7
5
4,5
8
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed,
m
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
Use the remote control from steps 3 to 8.
1
2
3
4
5
Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby
NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press the CD button and load the disc(s).
Press the E131T/CHECK button twice.
“EDIT” lights up and “PRGM” flashes on the display.
Press the numeric buttons to designate the tape
length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and O
buttons.
Maximum recording
Tape length
time for side A
I
I
Tape side A (front side)
Press one of the DISC DIRECT PLAY buttons to
select a disc and press the numeric buttons to
program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2 and the numeric buttons +10 and O.
6
7
8
Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Remaining time
of side A
Total number Programmed
of programmed tracks
tracks
Press the EDIT/CHECK button to select side B
and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
Press the ./0 REC/REC MUTE button and then
press the +
➤ button within 2 seconds to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press the
■ button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button to select side
A or B, and press the ++ or EF button repeatedly.
Program number
1
1
Track number Programmed
track numbers
To change the program of each side
Press the EDIT/CHECK button to select side A or B, and press
the
■ CLEAR button to clear the program of the selected side.
Then program tracks again.
To clear the edit program
Press the
■ button twice so that “EDIT disappears on the display.
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENGLISH 16