Filter
Top Products
PILAYING BACK A TAPE
MUSIC SENSOR
DO1.BY
Insert a tape,
1 Press the DOLBY NR button and turn Dolby NR
on or off to match the playback tape.
For tapes recorded with DOLBY NR, turn on IIU NR.
For tapes recorded without DOLBY NR, turn off DO NR.
2 Press the + ➤ button to start play.
The tape counter indicates
the tape running length.
I
Playback side of the tape
➤: The front side is being played (forward).
<: The back side is being played (reverse).
When tapes are loaded in both decks
Press the TAPE button first to select a deck.
The selected deck number is displayed.
To stop play, press the
❑ button.
To pause play (deck 2 only), press the II button. To resume
play, press again.
To change the playback side, press the 4> DIRECTION/
PRESET button in play or pause mode.
To fast forward or rewind, press the <+ or E> button in
stop mode. Then press the
■ button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE button. The power is turned on and play of the
inserted tape begins.
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
When the F indicator of the +E button is flashing, press
the >b button to move to the next track or the <4 button to
move to the beginning of the current track.
When the < indicator of the +> button is flashing, press
the +< button to move to the next track, or the k> button to
move to the beginning of the current track.
The search function uses a music sensor that may not be able
to detect tracks for tapes with:
● Blanks of less than 4 seconds between tracks
● Noisy blanks
● Long passages of low-end sound
● Low overall recording levels
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press the TAPE/DECKl/2 button to select the
deck to be played back first.
Press the REV MODE button to select Z).
Press the <> button to start playback.
Playback continues until the ❑ button is pressed.
To
set the tape counter to 0000
Press the
❑ CLEAR button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
ENGLISH
10