Filter
Top Products
28
Operator’s Guide
3M
™
Super Close Projection System SCP725
© 3M 2011. All Rights Reserved.
ENGLISH
Advanced Setup Menu
The Advanced Setup Menu, shown below, is used to initiate the PIN code feature (turn On/Off) and set the
PIN code.
Advanced Setup Input Source: Computer 1
PIN Authentication Off ►
Change PIN ►
Network Control Off ►
Closed Captioning Off ►
De-Magnify 0 |···········●············|
Pan Horizontal 0 |···········●············|
Pan Vertical 0 |···········●············|
New PIN
▄ ▄ ▄ ▄
Feature Description Range Default
PIN Authentication Turn the PIN code security feature On or Off. N/A Off
Set PIN code
Change the 4-digit PIN access code as desired.
Note: When PIN security is enabled, the PIN access
code will automatically set to the default value 3349.
0–9 3349
Network Control
Turns the network control function on and off. The
network control feature allows a computer to open
the control web page on I/O module and control the
projector.
To view the control web page, connect the I/O
module into the local area network and type the
I/O module's IP address into the address bar of a
web browser. (The IP address can be found in the
projector’s information menu. See the next page.)
The control web page will display. A RS-232 and
network control guide is available at www.mmm.
com\meetings in the Technical Documents section.
On/Off On
Closed Captioning
Turns on Closed Captioning. CC1, CC2, CC3, and
CC4 are the different Close Caption channels. CC1 is
the primary channel for most content. The content on
CC2, CC3, and CC4 may vary on video source.
Off / CC1 /
CC2 / CC3
/ CC4
Off
De-Magnify
Reduces the image size from 100% to 50% of the
projected image size.
50 to 100 100
Pan Horizontal Positions the image horizontally -5 to +5 0
Pan Vertical Positions the image vertically -5 to +5 0
Reset Reset setting to factory default.
28
ENGLISH