Filter
Top Products
19
Operator’s Guide
3M
™
Super Close Projection System SCP725
© 3M 2011. All Rights Reserved.
ENGLISH
ON/STANDBY ON: Press to turn projector ON.
OFF: Press to display confirmation message, press again to
switch projector to Standby mode.
Note: The confirmation message displays to ensure unit
does not get turned off accidentally.
INPUT/ SOURCE Press for current input source. Press again to select different
computer/video input.
Computer 1/Component 1 –> Computer 2/Component 2 –>
RCA Composite Video –> S-Video –> HDMI]
Volume + Press to increase speaker volume.
Volume – Press to decrease speaker volume.
Mute Press to switch the audio sound ON or OFF.
Menu
Press to display the Main Menu. When a menu is open, press
to exit menu.
L-Click
(top remote only)
Performs remote Left Mouse click function (when USB is
connected to projector USB)
R-Click
Performs remote Right Mouse click function (when USB is
connected to projector USB).
Up Arrow Moves cursor upward through menu items.
Down Arrow Moves cursor downward through menu items.
Left Arrow
Moves cursor left through menu items. Moves .ppt slides
backwards.
Right Arrow
Moves cursor to right through menu items. Moves .ppt slides
forward.
Mouse Pad
Allows remote mouse functions. Allows Pan function when
in Zoom mode.
Blank
Press to replace projected image with black image. Press
again to return projection image.
Freeze
Press to temporarily freeze movement on current image in
motion. Press again to return to active image.
Note: This function is intended for a few minutes only.
Timer
Press to initiate a 10:00 minute digital timer. Press up/down
arrows to change timer clock by 1 minute intervals up to
99:00.
Zoom +
Press and hold to increase the size of the displayed image up
to 200 percent.
Zoom -
Press and hold to decrease size of the displayed image down
to 100 percent
Trigger Button
(bottom remote only)
Pull trigger for remote LEFT mouse button functions. In
menu mode, use for remote Enter / Select functions.
Use a USB cable to connect from the PC to the SCP725 or SCP I/O Module (if equipped) and aim the remote
control toward the projection screen or at the IR sensor on the projector. Press desired remote control button to
send a signal to the projector.
Note: This projector is compatible with two remote control transmitters.
Remote Control Functions
Trigger button on
backside of remote
ON/
STANDBY
IN P UT/
SOURCE
MUTE
VOL
BLANK TIM ERFREEZ E
ZOOM
MENU