Filter
Top Products
21
Operator’s Guide
3M
™
Super Close Projection System SCP725
© 3M 2011. All Rights Reserved.
ENGLISH
Operating Instructions
Projector Start Up
Read the Important Safeguards before operating the SCP725. After all cable connections have been completed,
refer to Setup and Configuration, the projector can be powered up.
For best results, please observe the following start up sequence.
1. Power ON all of the connected equipment.
2. Plug the supplied power cord into the AC inlet of the projector.
3. Press the On/Standby button on the projector or remote control. The lamp will turn on and an image will
appear and grow brighter on the screen.
4. If the security feature is activated, enter the 4-digit PIN code.
a. Press the left/right arrow to move the cursor through each PIN field.
b. Press the up/down arrows to change the value in each field.
c. Press the Trigger button on the remote to enter the PIN access code.
PIN Code
5. Check all ventilation slots and clear away any obstructions.
6. Extend or retract front adjustment foot to obtain best image height.
Note: Rotate foot for fine adjustment.
7. Turn the focus adjustment (top of projector) to obtain the best image sharpness.
Stand By Mode
When an image is not being projected, place the unit into standby mode.
1. Press the On/Standby button on the Remote Control or the On/Off button on the I/O Box. When the
message “Press the power button to turn the unit off” displays, press the On/Standby button again.
2. The lamp will switch off and the power button will first turn red indicating the unit is in lockout and then
after 90 seconds the button turns amber to indicate the unit is in standby mode.
Note: In standby mode, the cooling fans will continue to run for 5 minutes and then turn off.