4. Lift out the reflector bowl and trim ring.
See “Cleaning chart” on page 29 for
cleaning instructions.
Replacing
1. Make sure all surface units are off and
cool before replacing surface units and
reflector bowls.
2. Line up openings in the reflector bowl
and notches in the trim ring with the
surface unit receptacle.
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle. Push the surface unit terminal
into the receptacle.
NOTE: Reflector bowls reflect heat back to
the utensils on the surface units. They also
help catch spills. When they are kept clean,
they reflect heat better and look new longer.
If a trim ring gets discolored, some of your
utensils may not be flat enough, or some
may be too large for the surface unit. In
either case, some of the heat that’s meant to
go into or around a utensil goes down and
heats the trim ring. This extra heat can
discolor it.
26
