C2674M-C (7/09) 15
PTZ Control
The PTZ control is available for cameras that support PTZ functions using Pelco C, Pelco P, and D protocols. It is also available for supported third-
party dome cameras. In addition, the PTZ option must be enabled and a protocol must be assigned to the camera channel. For information about
configuring camera features, refer to Camera Menu Setup on page 27. For information using the KBD300A keyboard to operate PTZ devices, refer
to Activating Presets on page 100.
NOTE: When operating third-party cameras, the PTZ control supports the up, down, left, right, zoom in, and zoom out functions.
Figure 4. PTZ Control
Move: Pan and tilts the camera in the direction of the selected arrow.
Exit: Closes the PTZ control.
ZOOM: Zooms the camera in and out.
FOCUS: Adjusts the camera focus.
IRIS: Opens and closes the camera iris.
PRESET NUMBER: Displays the preset number.
Keypad: Enters presets or pattern numbers.
PRESET: Performs two functions:
• Preset programming mode: Stores the preset in the selected memory location.
• PTZ mode: Activates a preset.
PATTERN: Performs two functions:
• Pattern programming mode: Stores the pattern in the selected memory location.
• PTZ mode: Activates a pattern.
Clear: Deletes a programmed preset, pattern, or tour.
Program: Accesses the camera programming mode.
Auxiliary: Selects the auxiliary mode. Buttons 1–4 select the camera’s auxiliary outputs. Buttons 1–4
operate as a toggle (on/off) each time they are selected.
SET: Performs two functions:
• Enters PTZ programming mode.
• Exits PTZ programming mode.
ZOOM
FOCUS
IRIS
PRESET
PATTERN
CLR
PGM
AUX
SET
