A SERVICE OF

logo

Open as PDF
next previous
154 Chapter 12 Installing Analog Terminal Adapters
N0008587 01
Mounting the ATA 2
After the ATA 2 is correctly connected, you can mount the unit on a wall, as described in this
section.
1 When using 0.5 mm wire (24 AWG), select a location within 800 m (2,600 ft.) of the
BCM1000.
2 Allow 12.5 cm (5 in.) clearance for the line jack, terminal jack, and power supply connector.
3 Screw two 4 mm (#8) screws into the wall, 130 mm (5 1/4 in.) away from each other. Leave
6 mm (1/4 in.) of the two screws showing.
4 Align the slots at the back of the ATA 2 unit over the screws. Push the unit against the wall.
The line jack, terminal jack and power supply connector must be at the top of the ATA 2. Refer
to Figure 63.
Figure 63 ATA 2 back view
Mounting keyhole slots