Radio PC Card Configuration 33
E-EQ-MX2RG-L-ARC MX2 Reference Guide
Proxim Parameters
The following is a list of parameters that can be modified in the NET.CFG file. To set the TCP/IP
parameters see the SOCKET.CFG file documentation.
Link Support
Parameter used to define resources for the LSL.COM file. Any modifications may cause resource
conflicts.
Protocol
Instructs TCP/IP stack to bind to radio driver.
Int
Sets the interrupt (IRQ) line to be used. MX2 specific setting is int 3.
Default: 3
Port
Sets the I/O port address. Use 300 for the MX2.
Default: 0x300
Mem#1 (ODI)
Memory_address sets the resource memory location (0xC000 to 0xE800). Upper memory blocks
from 0xA000 to 0xCFFF are used by MX2 system software.
Default: c100
Domain
Sets the network domain. It can be any number from 0 through 15 and must match the domain of
the server or access point to which you want to connect.
Valid: 0 through 15
Default: 0
Station_type
Sets the status of the PC card as a master (2), alternate master (1), or nonmaster (0) station.
Valid: 0, 1, 2
Default: 0
Socket
Sets the PCMCIA socket (A, B, C, or D) that has the PC card installed. The MX2 always uses
socket A for PC cards.
Valid: A, B, C D
Default: A
