xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
364
DGS–3426:5#show mac_based_access_control_local vlan default
Command: show mac_based_access_control_local vlan default
MAC Address VID
–––––––––––––––––
–––––
00–00–00–00–00–01 1
00–00–00–00–00–04 1
Total Entries:2
DGS–3426:5#
show mac_based_access_control auth_state
Purpose Used to display the MAC-based access control authenticated state.
Syntax
show mac_based_access_control auth_state ports <portlist>
Description This command is used to display the MAC-based access control authenticated state.
Parameters ports – Display MAC-based access control port state
Restrictions None.
Example usage:
To display the MAC-based access control authentication state:
DGS-3426:5#show mac_based_access_control auth_state ports 1-7
Command: show mac_based_access_control auth_state ports 1:1-1:7
Port MAC Address State VID Priority Aging Time/
Block Time
---- -------------------- -------------- ---- -------- ------------
Total Authenticating Hosts : 0
Total Authenticated Hosts : 0
Total Blocked Hosts : 0
DGS-3426:5#
config mac_based_access_control auth_failover
Purpose Used to configure the MAC-based access control authentication failover function.
Syntax
config mac_based_access_control auth_failover [enable | disable]
Description When the authentication failover is disabled and if the RADUIUS servers are
unreachable, the authentication will fail.
When the authentication failover is enabled, and if the RADIUS servers authentication is
unreachable, the local database will be used to do the authentication. The state is
disabled, by default.
Parameters enable – Enables the protocol authentication failover.
disable – Disables the protocol authentication failover.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
