xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
156
show autoconfig
Purpose Used to display the auto-configuration status.
Syntax
show autoconfig
Description The command is used to display the auto-configuration status.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To display the auto-configuration status:
DGS–3426:5#show autoconfig
Command: show autoconfig
Autoconfig State: Disabled
DGS–3426:5#
enable ipif_ipv6_link_local_auto
Purpose This command enables the auto-configuration of link local addresses when no IPv6
address is configured.
Syntax
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all ]
Description Enable the auto-configuration of link local addresses when there are no IPv6 addresses
explicitly configured. When an IPv6 address is explicitly configured, the link local address
will be automatically configured, and the IPv6 processing will be started. When there is
no IPv6 address explicitly configured, by default, link local address is not configured and
the IPv6 processing will be disabled. By enabling this automatic configuration, the link
local address will be automatically configured and IPv6 processing will be started.
Parameters
<ipif_name 12> − The name of the IP interface.
all – Indidcates all IP interfaces.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the automatic configuration of link local address for an interface:
DGS–3426:5#enable ipif_ipv6_link_local_auto all
Command: enable ipif_ipv6_link_local_auto all
Success.
DGS–3426:5#
