xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
19
DGS–3426:5#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DGS–3426:5#
disable web
Purpose Used to disable the HTTP–based management software on the Switch.
Syntax
disable web
Description This command disables the Web–based management software on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable HTTP:
DGS–3426:5#disable web
Command: disable web
Success.
DGS–3426:5#
save
Purpose Used to save changes in the Switch’s configuration to non–volatile RAM.
Syntax
save {[config <config_id 1–2> | log | all]}
Description This command is used to enter the current switch configuration into non–volatile RAM.
The saved switch configuration will be loaded into the Switch’s memory each time the
Switch is restarted.
Parameters config <config_id 1–2> – Specify to save current settings to configuration file 1 or 2.
log – Specify to save current Switch log to NV–RAM.
all – Specify to save all configuration settings. If nothing is specified after “save”, the
Switch will save all.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non–volatile RAM:
DGS–3426:5#save
Command: save
Saving all configurations to NV–RAM... Done.
DGS–3426:5#
