B-36 APPENDIX B: CLI COMMAND DESCRIPTION
set vc <vc_name> address_selection [negotiate | assign | specified]
bridging [enable | disable]
default_route_option [enable | disable]
destination_address [ip address]
end_time [ HH:MM:SS ]
header_compression [none | TCPIP]
idle_timeout [seconds]
input_filter [filter_name]
ip [enable | disable]
ip_routing [listen | send | both | none]
ip_source_validation [enable | disable]
ipx [enable | disable]
ipx_address [ipx_addr]
ipx_routing [all | listen | respond | send | none]
ipx_wan [enabled | disabled]
local_IP_address [ip_net_address]
mac_routing [enable | disable]
MTU [number]
NAT_option [disable | enable | nat | pat | super_nat]
PAT_default_address [ip_addr]
network_service [ppp | PPPLLC | RFC_1483]
output_filter [filter_name]
password [ password ]
remote_ip_address [ip_addr]
rip [ripv1 | ripv2]
rip_authentication [string]
rip_policies_update [rip_policies]
send_name [ ]
send_password [“text string”]
type [ONDEMAND | CONTINUOUS | MANUAL]
Specifies parameters for VCs.
session_timeout Interval before timing out a session.
tcp_port TCP Port number for the Telnet session.
Terminal_type The type of terminal. This is an alphanumeric string, of up to 64 characters.
