22 CHAPTER 4: WINDOWS NT
9 In the Network Services window, place a check mark in the box next to each
desired service. Unless you are following specific guidelines from your MIS
department, select the default settings.
10 Click Next to install the selected components.
11 When prompted, enter the path to the Windows NT installation files (for
example, D:\i386 on the NT CD) and click Continue.
When the system prompts again for NT files, specify a:\NT40 and click Continue.
12 In the 3Com LAN+Modem card dialog box, accept the default settings and click
Continue.
13 When the window for enabling or disabling protocols opens, click Next.
14 When NT is ready to start the network, click Next to copy the network files.
15 Provide your computer name and workgroup or domain name when prompted.
16 When the system displays “Networking has been installed on your computer,”
click Finish.
17 When prompted to reboot the computer, remove the Windows 95/98
Installation Disk from the floppy drive and click Yes.
Installing the Modem
Interface
For modem installation, you must be ready to assign a COM port to the
modem. The following procedure assumes you will create a new COM port for
this purpose. If you plan to use an existing COM port, make sure it is not being
used by another device, such as a built-in infrared port.
1 Open the Control Panel and select Ports.
2 Click Add to create a new COM port.
3 Set the COM port number to 5 or higher. (Do not give the new port the same
number as an existing COM port.)
4 Accept the default settings for the new port (typically, IRQ 15 and I/0 3f8) and
click OK.
5 Do not reboot the system when prompted. Select Do not reboot now and
continue with the procedure.
6 Open the Control Panel and select Modem.
7 Select Do not detect my modem... and click Next.
8 Click Have Disk. Insert the LAN+Modem card Windows 95/98 Installation Disk
into the floppy drive. Specify a:\NT40 as the location of the modem files and
click OK.
9 Select 3Com 10/100 LAN + 56K Modem CardBus PC Card and click Next.
10 Select the COM port created in steps 1 through 4 above and click Next.
11 If prompted for dialing options, specify the settings you will use and click Next.
12 In the Modem Properties window, review the modem settings and click Close.
13 Remove the Windows 95/98 Installation Disk from the floppy drive. You do not
have to reboot the computer.
