5-14 C
HAPTER
5: N
OVELL
IPX R
OUTING
The IPX network number of the numbered link must be the same as
that entered for this link in the central site ISDN Numbers table.
6
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Enable IPX Routing
1
Enter
CO
RO
PA
to display the Router Options screen.
2
Toggle the IPX Routing field to
ENABLED
using the Spacebar.
3
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Submitting the new setting turns IPX routing on.
4
Enter
QUIT
to return to the central site unit management session.
5
Enter
CO
IS
NU
to display the ISDN Numbers screen. Use the Arrow
keys to select the remote unit entry.
6
Enter
CANC
to cancel the manual call.
7
Enter
SAVE
to save the new configuration at the central site.
Although the remote site configuration has not been permanently
saved, the unit is functioning as an IPX router.
Enable Novell RIP/SAP Learning
Novell RIP/SAP learning must be enabled at both ends of the link.
1
Enter
CO
BR
PA
to display the Filter Parameters screen.
2
Toggle the Learn Novell RIP/SAP field to
ENABLE
using the Spacebar.
3
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
NRIP and SAP tables will be built automatically during normal operation
of the unit.
The remote configuration of the remote unit will not be successful
unless Novell RIP/SAP learning has been enabled on
both
ends of the
link.
Manual Call
A manual call must be made to the remote site unit to enable the IPX
Autocall table to be built automatically on the remote unit. This call is
Get_con.bk : IPX_ROUT.FRM Page 14 Friday, October 3, 1997 1:49 PM
