Yamaha YSP-4100BL Speaker System User Manual


 
41 En
PREPARATIONINTRODUCTION APPENDIXPLAYBACK FEATURES SETTINGS
Customizing this unit
(SET MENU)
System
configurations
(ADVANCED SETUP)
Using an external
amplifier
Controlling external
components
R.INPUT POWER (Power-on by remote control
input keys)
Select whether or not to automatically turn on this unit
when you select an input source on the remote control. To
enable the function, select “R.INPUT PW: ON”.
Choices: R.INPUT PW: OFF*, R.INPUT PW: ON
AC ON STANDBY (Standby after AC on)
Set this unit to the standby mode when the AC power is
recovered after the power to this unit was lost temporally
(disconnect the AC power plug from the wall outlet, power
outage, etc.). To enable the function, select “AC
STANDBY: ON”.
Choices: AC STANDBY: OFF*, AC STANDBY: ON
SIRIUS PIN (SIRIUS Satellite Radio PIN)
Reset the Parental Lock cord for SIRIUS Satellite Radio.
Choices: CANCEL*, RESET
MEMORY PROTECT (Memory protect)
Protect the settings you have saved in the system memory.
To protect the settings, select “PROTECT: ON”.
Choices: PROTECT: OFF*, PROTECT: ON
DEMO MODE (Demo mode)
Test the sound beam output from this unit to experience
the sound beam. To set this unit to the demo mode, select
“BEAM DEMO: ON”.
Choices: BEAM DEMO: OFF*, BEAM DEMO: ON
To move the beam horizontally, turn off this unit and
then turn on it again (“DEMO” appears on the front
panel display). Playback an input source and then press
EOFF.
To stop the beam movement, press EOFF again.
To adjust the beam angle manually, press
FSURROUND or FSTEREO when the beam is not
moving.
y
After you checked the sound beam output, set this setting to
“BEAM DEMO: OFF”.
If you set “SOUND OUT” to “PRE OUT”, “DEMO MODE”
does not function.
FACTORY PRESET (Factory preset)
Reset all of the parameters of this unit to the factory
presets.
Choices: CANCEL*, RESET
You can connect an external amplifier to the PRE OUT jacks. Set “SOUND OUT” (page 37) to “PRE OUT” and then
configure “PRE OUT BASS Management” parameters.
See also: “Changing the audio output method for surround playback” (page 23)
1 FRONT PRE OUT jacks
Output front right and left channel signals.
2 SURROUND PRE OUT jacks
Output surround right and left channel signals.
3 SUR. BACK PRE OUT jacks
Output surround back right and left channel signals.
4 CENTER PRE OUT jack
Outputs center channel signals.
5 SUBWOOFER PRE OUT jack
Connect a subwoofer with a built-in amplifier.
Note
The following functions are disabled when an external amplifier
is used.
AUTO SETUP (page 15)
CINEMA DSP programs (page 22)
UniVolume (page 31)
MUSIC ENHANCER (page 37)
BASS EXTENSION (page 37)
Adaptive DRC (page 37)
Using an external amplifier
FRONT
PRE OUT
SURROUND SUR. BACK
5
1234