Filter
Top Products
49
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
Pressing n always selects OPTN first
SELECT
SOURCE
Pressing k selects “Zone2” first
6CH INPUT
SOUND
TITLE
MENU
CHAPTER
PAU S ESTOPPOWER
REC
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
–+
ENTER
6CH INPUT
SOUND
TITLE
MENU
CHAPTER
PAUSESTOPPOWER
REC
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
– +
ENTER
■ SOURCE SELECT k / n
You can control another component independently from
the input you have selected by pressing an input selector
button.
Press SOURCE SELECT k / n to choose the
component and set the remote control to be
used for it.
The display window will show one of the following:
(when pressing n) OPTN (option), Å, ı, PHONO,
V-AUX, TUNER, MD, CD-R, CD, TV/LD (TV or
digital TV/LD), CBSAT (cable TV/satellite tuner),
VCR 1, VCR 2, DVD.
y
• Pressing k shows the same in the reverse order, but you cannot
select OPTN.
■ OPTN (option) area
OPTN is an extra component control area that can be
programmed with other remote control functions.
Note
• You cannot set up the manufacturer code in this area. See
page 44 for the programming procedure.
■ Zone 2 feature
When you make up a second audio-video room with this
unit’s Zone 2 feature, you must set “Zone2” as the
amplifier library in the remote control first. Selecting
“Zone2” by pressing k sets the remote control to the
Zone 2 mode. See pages 68 and 69 for details.
2 Press MACRO to clear a programmed macro
by using a ballpoint pen or similar object.
3 Press and hold CLEAR by using a ballpoint
pen or similar object, and at the same time
press the button for which you want to clear
the macro for about 3 seconds.
“C:OK” appears in the display window.
y
• You can clear other learned functions and macros at this time
by holding down CLEAR again and pressing the other buttons
for which those learned functions or macros have been
programmed.
Note
• “C:NG” appears in the display window if the operation is
unsuccessful. In this case, try step 3 again.
4 Press MACRO again to exit from the clearing
mode.
Once you have cleared a learned function or macro
for a button, the button reverts to the factory setting.
MACRO
MACRO
CLEAR
0108V2200_42-54_EN(U) 01.8.1, 2:53 PM49