Filter
Top Products
1
2 Select the reception band (FM or AM) while watching
the display.
3
4
For FM reception, set the MODE, BLEND and IF MODE
buttons as desired. (Refer to page 8 for details.)
5 Tune to a desired station.
To tune to a higher frequency, slightly turn the control
to the right. To tune to a lower frequency, slightly turn
the control to the left.
6 If the station where tuning search stopped is not the
desired one, follow step 5 again.
* If the tuning search does not stop at the desired
station, change to the MANUAL TUNING method as
described on the following page.
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
AUTOMATIC TUNING
7
English
TUNING OPERATIONS
Display information
➀
Displays the band and frequency of the received station.
* If an RDS station is received, the frequency is then
replaced by the station name. (However, if the PS data
cannot be received within 5 seconds, “NO PS” flashes,
and then it returns to the frequency display.)
Refer to page 14 for details.
➁
Illuminates when an FM stereo broadcast is received in
stereo.
➂
Indicates the signal level of the received station.
1
4
23
5, 6
POWER
FM/AM
TUNING MODE
AUTO/MAN’L
WIDE
AUTO TUNING
0 10050
STEREO
TUNING
TUNING
AM
FM
or
FM MHz
WIDE
AUTO TUNING
0 10050
STEREO
➀➁
➂