Filter
Top Products
11
English
AUTOMATIC PRESET TUNING
You can also make use of an automatic preset tuning function for RDS stations only. By this function, this unit performs automatic
tuning and stores RDS stations with strong signals sequentially. Up to 40 stations are stored automatically to the preset station
buttons in the same way as in the manual preset tuning method on page 9.
To store stations
1
2
Flashes.
3 Slightly turn the TUNING control to the right (or to the
left).
* When turned to the right, automatic tuning is
performed toward higher frequencies. When turned
to the left, automatic tuning is performed toward lower
frequencies.
This unit performs automatic tuning and received RDS
stations are programmed to A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to other pages (B, C, D and E) of preset
station buttons in that order.
After the automatic preset tuning is completed
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on page 9.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on page 9. A recalled station is shown by the
frequency or station name on the display.
Notes
●
The automatic preset tuning search will be performed
through all RDS network frequencies until 40 stations are
stored. If the number of received stations is less than 40,
the search will stop after searching through all stations.
●
With this function, the settings of the MODE, BLEND and
IF MODE buttons are stored along with stations.
●
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want
to program is weak in signal strength, tune to it in
monaural manually and program it by following the
procedure of the section “To store stations” on page 9.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.
●
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section “To store stations” on page 9.
Press and
hold for about
3 seconds.
1
3
2
FM/AM
FM
MEMORY
MAN’L/AUTO FM
FM MHz
MEMORY AUTO ST
WIDE
AUTO TUNING
0 10050
STEREO
TUNING