Filter
Top Products
1
2 Turn the unit into the PS mode.
* If “NO PS” flashes, proceed to the next step while flashing.
If “NO PS” disappears before you proceed to the next step,
press the FREQ/PS/PTY button again.
3
4 Select the first letter or numeral of the station name.
* By turning the TUNING control, the display will change
letters and numerals in sequence.
* If you will not input the second letter, skip to step 7.
5 When the first letter or numeral of the station name
appears, press the SHIFT button to proceed to the
selection of the next letter or numeral.
6 Repeat steps 4 and 5 for other letters and/or numerals,
if necessary.
7 After you finished inputting the name, press the ENTER
button.
8
The unit begins searching the station, and it is continued
until the station is found.
You do not have to input a full name for searching
the station
You may input only the first letter of the station name. In this
case, you can skip steps 5 and 6. In step 8, the unit searches
and calls a nearest station which has the letter you input. If
the station is not the desired one, turn the TUNING control
again. The unit will begin searching another station which has
the letter.
To cancel this function
Press the AF, FREQ/PS/PTY, SHIFT, ENTER, FM/AM or
MEMORY button.
Notes
●
If no station is found by this function after searching
through all preset stations, “NO PS” flashes for about 3
seconds on the display, and then it returns to the mode
which had been obtained before the searching was
performed.
●
This function is useful especially for calling a station with
weak signals which cannot be received by the automatic
tuning method. By only storing such a station, you can call
it any time easily.
15
English
Calling a preset RDS station by the station name (PS SEEK)
You can call a desired RDS station stored in this unit by only inputting the name of the station in the PS mode. By this operation,
this unit searches the station from among all preset stations. You do not have to input a full name, even only the first letter can be
used for calling. As many as 8 letters and/or numerals can be selected for inputting a name.
* If you had stored an FM station other than an RDS station with a name of your own giving, it can also be called by inputting the
name.
4, 8
2
1
7
3, 5
FM/AM
FM
PS/PTY SEEK
FREQ/PS PTY
SHIFT
ENTER
A station name is
displayed or “NO PS”
flashes.
Flashes
PS/PTY SEEK
FREQ/PS/PTY
SHIFT
ENTER
TUNING
“A” will flash on the second
letter or numeral position.
PS/PTY SEEK
FREQ/PS/PTY
SHIFT
ENTER
The name will illuminate.
PS/PTY SEEK
FREQ/PS/PTY
SHIFT
ENTER
ENTER
TUNING
Slightly turn.