Yamaha RX-V563 Stereo Receiver User Manual


 
RECORDING
62 En
Recording adjustments and other operations are performed from the recording components. Refer to the operating
instructions for those components.
When this unit is set to the standby mode, you cannot record between other components connected to this unit.
TONE CONTROL (see page 43) and VOLUME settings, speaker levels (see page 43) and the sound field programs (see page 40) do
not affect recorded material.
The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
The XM Satellite Radio signals cannot be output at the AUDIO OUT (REC) jacks.
The SIRIUS Satellite Radio signals cannot be output at the AUDIO OUT (REC) jacks.
Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Therefore, if
your source component is connected to provide only digital signals, you cannot record the source.
S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing
video signals input from a video source component that provides only an S-video or a composite video signal, you can record only an
S-video or a composite video signal on your DVD recorder.
A given input source is not output on the same OUT (REC) channel.
The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.
Once you have connected a recording component to this unit, keep the component turned on while using this unit. If the component is
turned off, this unit may distort the sound from other components.
Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright
laws.
y
Do a test recording before you start an actual recording.
1 Turn on all the connected components.
2 Press
R
INPUT
l / h repeatedly (or press
one of the input selector buttons (4)) to
select the source component you want to
record from.
3 Start playback on the selected source
component or select a broadcast station.
4 Start recording on the recording component.
Recording
Notes
If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture
itself may be disturbed due to those signals.
01EN_RX-V563_U.book Page 62 Thursday, January 31, 2008 10:28 AM