Yamaha RX-V563 Stereo Receiver User Manual


 
55 En
SIRIUS Satellite Radio™ tuning
English
BASIC
OPERATION
All Channel Search mode
1 Press
D
SEARCH MODE (or
M
SRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2 Press
G
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
You can search for a channel quickly by pressing and holding
G
PRESET/TUNING/CH l / h
(or
8
PRESET/CH k / n).
You can skip channels to the previous or next category by
pressing
F
CATEGORY (or
8
A-E/CAT. l / h).
Category Search mode
1 Press
D
SEARCH MODE (or
M
SRCH
MODE) repeatedly to select “CAT SEARCH”.
2 Press
F
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the channel category.
3 Press
G
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
G
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n).
This unit skips the channels when this unit is All Channel Search
mode or Category Search mode in the following cases (it is not
malfunction of this unit):
– the channel is locked (see page 56).
– the channel is out of service.
– you do not subscribe to the channel.
Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
“Setting the SIRIUS Satellite Radio™ preset channels” on
page 56.
1 Press
D
SEARCH MODE (or
M
SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2 Press
F
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3 Press
G
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (
G
).
Direct Number Access mode
1 Press
M
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
2 Press the numeric buttons (
G
) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (
G
) as shown below.
y
To display the SIRIUS Radio ID (SID) number displayed in the
front panel display, select channel “0”.
To enter a one-digit or two-digit channel number, press the
numeric buttons (
G
) on the remote control and then press
T
ENT to confirm the input number.
Instead of pressing
T
ENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
Pressing a button other than the numeric buttons (
G
) or
T
ENT
cancels the Direct Number Access mode procedure.
If the selected channel is locked, “PIN:____” appears in the
front panel display. Enter the four-digit Parental Lock code
number by using the numeric buttons (
G
) or press
T
ENT to
cancel.
Before performing the following operations, press
K
SIRIUS.
Note
1 2 3
01EN_RX-V563_U.book Page 55 Thursday, January 31, 2008 10:28 AM