Filter
Top Products
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu) En 83
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press
z (power).
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press z (power) to set the unit to standby mode and turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
Changing the speaker impedance setting (SP IMP.)
(U.S.A. and Canada models only)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Selecting the remote control ID (REMOTE ID)
Change the unit’s remote control ID so that it matches the remote control’s ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■ Changing the remote control ID of the remote control
1
To select ID1, while holding down the cursor key (e), hold down SCENE (BD/DVD)
for more than 3 seconds.
To select ID2, while holding down the cursor key (e), hold down SCENE (TV) for
more than 3 seconds.
• The registered remote control codes (p.85) are not cleared even if you change the remote control ID.
Configuring the system settings
(ADVANCED SETUP menu)
Item Function Page
SP IMP.
(U.S.A. and Canada models only)
Changes the speaker impedance setting.
83
REMOTE ID Selects the unit’s remote control ID. 83
TU
(Asia and General models only)
Changes the FM/AM tuning frequency setting.
84
TV FORMAT Switches the video signal type of HDMI output. 84
INIT Restores the default settings. 84
UPDATE Updates the firmware. 84
VERSION Checks the version of firmware currently installed on the unit. 84
z (power)
STRAIGHTPROGRAM
6 Ω MIN
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
8 Ω MIN (default)
Select this option when you connect 8-ohm or higher speakers to the
unit.
SPIMP.8MIN
REMOTEIDID1