Filter
Top Products
PREPARATIONS ➤ Placing speakers En 12
Select the speaker layout for the number of speakers that you are using and place the speakers and subwoofer in your room. This section describes the representative speaker layout
examples.
* RX-V575 only
• RX-V575 supports 2- to 7.1-channel system, and RX-V475 supports 2- to 5.1-channel speaker system.
• (RX-V575 only)
Two subwoofers connected to the unit output the same sounds.
1 Placing speakers
Caution
• (U.S.A. and Canada models only)
Under its default settings, the unit is configured for 8-ohm speakers. When connecting 6-ohm speakers, set the unit’s speaker impedance to “6 Ω MIN”. In this case, you can also use 4-ohm speakers as the front speakers.
For details, see “Setting the speaker impedance” (p.14).
• (Except for U.S.A. and Canada models)
Use speakers with an impedance of at least 6 Ω.
Speaker type Abbr. Function
Speaker system (the number of channels)
7.1* 6.1* 5.1 4.1 3.1 2.1
Front (L) 1
Produce front right/left channel sounds (stereo sounds).
●●●●●●
Front (R) 2 ●●●●●●
Center 3 Produces center channel sounds (such as movie dialogue and vocals). ●●● ●
Surround (L) 4
Produce surround right/left channel sounds.
●●●●
Surround (R) 5 ●●●●
Surround back (L)* 6
Produce surround back left/right channel sounds.
●
Surround back (R)* 7 ●
Surround back* 8 Produces sounds mixed from surround back left/right channel sounds. ●
Subwoofer 9
Produces LFE (low-frequency effect) channel sounds and reinforces the bass parts of other channels.
This channel is counted as “0.1”.
You can connect 2 subwoofers (with built-in amplifier) to the unit.*
●●●●●●
1
Speaker placement
2 3 4 5 6 7 8 9 10