Filter
Top Products
80 En
Customizing this unit (MANUAL SETUP)
■ Audio settings E)AUDIO SET
Tone bypass TONE BYPASS
Use this feature to select whether the audio output
bypasses the tone control circuitry when “TREBLE” and
“BASS” are set to 0 dB (page 46).
HDMI audio HDMI AUDIO
Use this feature to select the types of the audio signals
output at the HDMI OUT jack on the rear panel of this
unit.
Available audio/video signals depend on the specification of the
connected video monitor. Refer to the instruction manuals of
your video monitor and audio source component.
■ Pure direct F)PURE DIRECT
Use this feature to select whether this unit outputs the
video signals when this unit is in the Pure Direct mode.
You cannot use the OSD menu even if “PURE DIRECT” is set
to “AUDIO+VIDEO”.
Use this feature to adjust the video parameters.
y
You can reset the all parameters in “VIDEO MENU” to the
initial factory settings by using “VIDEO” of “INITIALIZE” in
“ADVANCED SETUP” (page 103).
Video conversion VIDEO CONV.
Use this feature to set whether to convert the video signals
input at the VIDEO, S VIDEO, and COMPONENT
VIDEO jacks.
• This unit does not convert 480 line video signals and 576 line
video signals interchangeably.
• 480p-, 576p-, 1080i- and 720p-resolution video signals cannot
be output at the S VIDEO and VIDEO MONITOR OUT jacks.
• The converted video signals are only output at the MONITOR
OUT jacks. When recording a video source, you must make the
same type of video connections between each component.
• When composite video or S-video signals from a VCR are
converted into component video signals, the picture quality may
suffer depending on your VCR.
• Unconventional signals input at the composite video or S-video
jacks cannot be converted or may be output abnormally. In such
cases, set “VIDEO CONV.” to “OFF”.
Component interlace/progressive up-conversion
COMPONENT I/P
Use this feature to activate or deactivate the analog
interlace/progressive conversion of the analog video
signals input at the composite video, S-video and
component video jacks so that the analog video signals
deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p
are output at the COMPONENT MONITOR OUT jacks.
Choice Functions
AUTO
Automatically bypasses the tone control
circuitry to provide the purest signal possible
when “TREBLE” and “BASS” are set to 0 dB.
OFF
Does not bypass the tone control circuitry.
Choice Functions
AMP
Outputs audio signals that can be decoded by
this unit.
AMP+TV
Outputs audio signals that can be decoded by
your video monitor connected to the HDMI
OUT jack of this unit.
Note
Choice Functions
AUDIO
Does not Output video signals.
AUDIO+VID
EO
Outputs video signals. For the better sound
quality, this unit only activates the limited video
features.
Note
4 VIDEO MENU
Choice Functions
ON
Converts composite, S-video, and component
video signals interchangeably and up-converts
composite, S-video, and component video
signals to HDMI video signals.
OFF
Does not convert any signals.
Notes
Choice Functions
ON
Activates the analog interlace/progressive up-
conversion of the analog video signals.
OFF
Deactivates the analog interlace/progressive up-
conversion of the analog video signals.