Filter
Top Products
Fig. 63A - Input Splitter Transformer Setup to Operate P-2200 in "Mono" Mode.
Fig. 63B - Output Connections for Operating P-2200 in
"Mono" Mode.
In the "mono" mode, the P-2200 will produce a full
400 watts
into
a
16-ohm
load. The
voltage
output
from
the P-2200 in the mono mode is approximately 75
volts RMS, and since it can drive even highly reactive
loads with complete stability, it is suitable for driving
70-volt (constant voltage) commercial sound speaker
lines. In all but very small systems, the P-2200 can offer
cost
savings
when compared
to
multiple,
low-power
amplifier installations. In addition, the P-2200's per-
formance specifications far exceed most commercial
sound amplifiers. Figure 76 illustrates a typical 70-volt
constant voltage system (also called a "distributed"
system since there are usually a number of speakers
distributed throughout a building).