Filter
Top Products
49
English
BASIC OPERATION
ADVANCED OPERA
TION
APPENDIX
INTRODUCTION
PREPARATION
Returning to the Factory Setting
■ To return to the factory-set codes
in all modes
1 Press one of the
component selector
buttons other than
AMP(TUNER).
2 Press both VOLUME
buttons (u/d) at the same
time for about four
seconds.
The indicator flashes twice.
3 Enter the code number
“9990”.
Make sure that the indicator
flashes twice.
■ To return to the factory-set codes
in each mode
1 Press one of the
component selector
buttons which
corresponds to the
component to be returned
to the factory-set code.
2 Press both VOLUME
buttons (u/d) at the same
time for about four
seconds.
The indicator flashes twice.
3 Enter the code number
“0000”.
Make sure that the indicator
flashes twice.
PRESET REMOTE CONTROL
The following codes are factory set.
Component selector button Component Code Set component Set code
TV TV 0101
CBL/SAT Cable TV 0006
VCR VCR 0002
DVD/LD DVD player 0008 (YAMAHA DVD player)
CD CD player 0005 (YAMAHA CD player)
TAPE/MD MD recorder 0024 (YAMAHA MD recorder)
We recommend that you write all the code numbers you have set on the table above.
0108V520RDS43-49_EN 1/31/1, 4:24 PM49