Filter
Top Products
41
English
BASIC OPERATION
ADVANCED OPERA
TION
APPENDIX
INTRODUCTION
PREPARATION
DELAY TIME AND SPEAKER OUTPUT LEVELS
1
3
2
DELAY
CENTER
R SUR.
L SUR.
SWFR
Adjusting Method
Adjustments should be performed with the remote control
while watching the information on the display.
1 Press AMP(TUNER) on the
component selector.
2 Press TIME/LEVEL repeatedly to select the
item you want to adjust.
Each time you press TIME/LEVEL, the selected item
changes and appears on the display as below.
Delay time
Center speaker output level
Right rear speaker output level
Left rear speaker output level
Subwoofer output level
Note
• Depending on the setting of the SET MENU, you may not be able
to select all these items.
3 Press – or + to adjust the
delay time or speaker
output levels.
4 Repeat steps 2 and 3 to adjust the settings of
any other item.
Notes
• If “CENTER SP” or “REAR LR SP” is set to NON, or “BASS
OUT” is set to MAIN, the output level of that speaker cannot be
adjusted.
• When you adjust the output level with TIME/LEVEL, the settings
you made with the test tone will be changed.
• To adjust speakers other than the subwoofer, the adjusting
procedure using test tones on page 19 is recommended.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost when this unit is set in the standby mode.
If, however, the power cord is disconnected from the AC
power outlet or the power is cut for more than one week,
the latest values for the delay time and the center/rear/
subwoofer output levels that were set will automatically
return to the preset values. If so, adjust the delay time
and output levels again.
0107V520RDS35-42_EN 1/31/1, 4:23 PM41