Filter
Top Products
E-53
English
1
PLAYBACK
2
REC/PLAYBACK
EJECT
OPEN/CLOSE
DISC CHANGE
Active Servo
Technology
1
2
3
DISC
PROGRAM
USER
VOLUME
DOWN UP
MEMORY
DOWN UP
REC/PAUSE
MODE
HOUR MIN
NORMAL
DUBBING
HIGH
MEMORY
TIME ADJ
DOLBY NR
AUTO/MAN’L
TIMER
TIMER REC
MUSIC
POWER
PHONES
PRESET/TUNING/BAND
A/B/C/D/E
RANDOM
REPEAT
EDIT
DISPLAY
CD
INPUT INPUT
TAPE 1/2
START
MODE
FREQ PS/PTY/RT/CT
PTY SEEK
EJECT
MINI COMPONENT SYSTEM
GX
–
70
➂ At ON TIME/time setting mode
[“ON TIME” appears on the display, and soon it is
changed to a time setting mode.]
Set to the time when you want to begin the timer play
by using the HOUR button and the MIN button.
➃ At OFF TIME/time setting mode
[“OFF TIME” appears on the display, and soon it is
changed to a time setting mode.]
If necessary, set to the time when you want to finish
the timer play (to turn this unit off) by using the HOUR
button and the MIN button. Even if you do not set the
time, it has already been set so that the timer play
finishes after 1 hour.
* The TIMER button functions also in the time (ON
TIME or OFF TIME) setting mode. (However, it also
turns off the power.)
3 If you will not use this unit until the timer play begins, turn
the power off by pressing the POWER switch or the
TIMER button.
Note
If a timer play setting is made and the power is not turned off,
the source set for the timer play will begin playing when the
time comes in place of the source played at that time.
To cancel the timer play setting
After the timer play is finished, press the DISPLAY button to
call the current time. While the current time is displayed,
press the TIMER button so that “TIMER” goes out from the
display.
If it is not canceled, the system will be turned on at the same
time every day, so it can be used as an alarm. However, if
you are planning to go out at that time, cancel the timer play
setting.
* Unless the AC supply lead is unplugged or there is a
power failure for more than 5 minutes, the time set on the
timer will be retained until it is reset.
How to make time setting in the ON TIME or OFF
TIME mode
For the hour:
Press the HOUR button to change the hour to a higher value.
Press and hold to change continuously.
To change the hour to a lower value, press the button.
For the minute:
Use the MIN button and operate it in the same way as you
did to change the hour.
To change the minute to a lower value, press the
button.
HOW TO USE THE BUILT-IN TIMER
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B
TAPE
C
EDIT
D
+I0
E
OPEN
/
CLOSERANDOM
REPEATMODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
TAPE
STOP
STOP
PLAY
/
PAUSE
PLAYPLAY
REC
/
PAUSE TAPE 1
/
2
LEVEL MUSIC
TEST FLAT
CENTER
/
REAR
/
DELAY
PROGRAM
USER
POWER
INPUTSLEEP
VOLUME
TIMERPOWER DISPLAY
HOUR
MIN
POWER