Filter
Top Products
E-13
English
Connecting external components
(See figure 9 on page 1111.)
This system can be connected with external audio and video
components. Make connections between this system and
other components using RCA pin plug connector cables
correctly, that is to say L (left) to L and R (right) to R. Also,
refer to the owner’s manual for each component to be
connected to this system.
Connecting the AC supply lead
(See figure @ on page 1122.)
•
After completing all connections, plug the AC supply lead
into a convenient AC outlet.
•
Unplug the AC supply lead from the AC outlet if the unit is
not to be used for a long period of time.
CONNECTIONS
(See figure A on page 1122.)
The front grille is fastened to the enclosure at four points, and
can be removed if desired. To remove the grille, first hold the
bottom of the grille and unfasten the lower part of the grille by
pulling it gently, and then hold both sides of the grille and
slowly pull straight away from the speaker. To reattach, line
up the four pegs on the inside surface of the grille with the
four corresponding holes on the speaker and push gently.
Note
When the grille is removed, take care not to touch the
speaker units with your hands or to exert excessive force with
tools.
REMOVING THE FRONT GRILLES OF FRONT SPEAKERS
(See figure B on page 1122.)
•
Be sure that your headphones have a 3.5 mm (1/8”)
diameter plug and are between 16 ohms and 50 ohms
impedance. Recommended impedance is 32 ohms.
•
When headphones are connected, the speakers are
defeated automatically and you can listen to the sound to
be output from the front speakers through headphones.
Adjust the VOLUME control for desired volume.
LISTENING WITH HEADPHONES
STANDBY mode
While the power is on, pressing the POWER switch (or the
POWER switch on the remote control transmitter) switches
the system to the STANDBY mode. (In this mode, the
display shows only the time.) In this mode, main voltage is
still present inside the system. If you want to switch off the
system completely, disconnect the AC power plug from the
AC outlet.
TURNING THE POWER ON/OFF TO THIS SYSTEM
(See figure C on page 1122.)
If the AC supply lead is connected to the AC outlet, this
system can be turned ON and OFF (STANDBY mode) by
pressing the POWER switch on the front panel of the main
unit or the POWER switch on the remote control transmitter.
Automatic power-off function
The power of this system will be automatically turned off if
there is no operation on the control parts of this system, no
illumination on the graphic equalizer level indicators and no
playback of CD or tape for about 30 minutes.
* This function is not available unless time setting is made
on the built-in clock.