Filter
Top Products
E-18
1
1
2
2
3
3
4
4
5
5
+I0
E
6
6
7
7
8
8
9 0
CD
PRESET
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B
TAPE
C
EDIT
D
+I0
E
OPEN
/
CLOSERANDOM
REPEATMODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
TAPE
STOP
STOP
PLAY
/
PAUSE
PLAYPLAY
REC
/
PAUSE TAPE 1
/
2
LEVEL MUSIC
TEST FLAT
CENTER
/
REAR
/
DELAY
PROGRAM
USER
POWER
INPUTSLEEP
VOLUME
COMPACT DISC PLAYER OPERATION
Direct operation
When the power is off (in the standby mode), pressing the
CD input selector button or the DISC selector (1, 2 or 3)
button will turn the power on and start CD playback
automatically.
When the power is on, even if an input source other than CD
player is selected, pressing a DISC selector button or closing
the disc table by pushing the front edge of the disc table
gently will start playback directly. In this case, if the tape
deck is playing back a tape, it will be stopped automatically.
* These ways of playback can also be used to close the disc
table. If the table is closed in these ways, playback will
begin automatically, however, the display will not show the
total number of tracks and the total playing time of the disc
to be played back.
PLAYXCHANGE
During playback, you can open the disc table by pressing the
DISC CHANGE button without interrupting playback.
However, in this case, pressing the DISC SKIP button or a
DISC selector button has no effect.
Precautions
•
If TV or radio interference occurs during CD player
operation, move the unit away from the TV or radio.
•
Subjecting the unit to shock or vibration can cause
mistracking.
•
Playing back some compact discs at high volume can
cause mistracking. In this case, listen at lower volume.
•
Do not pull open the disc table forcibly with your hands.
•
Do not push the disc table while it is moving.
•
If the power fails while the table is open, wait until the
power supply returns or gently push the table manually to
close it.
•
The temperature range for playing back compact discs is
recommended to be 5°C (41°F) – 35°C (95°F).
Direct-selection playback
By using the track number input buttons on the remote
control transmitter, any track you wish to listen to can be
played back directly.
Use the track number input buttons to select the desired
track number. Playback will begin automatically.
A. For example, to choose selection 5
Press the “5” button.
B. For example, to choose selection 12
(1)Press the “+10” button.
(2)Within 3 seconds, press “2” button.
C. For example, to choose selection 20
(1)Press the “+10” button.
(2)Within 3 seconds, press the “+10” button again.
(3)Within 3 seconds, press the “0” button.
Note
If you select a track number higher than the number of tracks
on the disc, playback will begin from the last track on the
disc.
To interrupt playback
1 Press the play/pause / button.
* The “ ” indicator will flash.
2 Press the play/pause / button to resume playback
from the same point.
To stop playback
Press the stop button.
To switch the unit off after use
Turn the unit off by pressing the POWER switch. (The
indicators will go off except for the current time display.)