CONNECTIONS
12
■ Placing the center speaker
When placing the center speaker on top of the TV, use the
supplied fasteners to secure the speaker.
1 Peel off the seals on one side of the fasteners and
attach them to the bottom of the center speaker.
2 Peel off the seals on the other side of the fasteners and
attach them to the top of the TV.
– Do not place the speaker on the TV if the top of the
TV is uneven or narrower than the bottom surface
of the speaker. Doing so may cause the speaker to
fall. In this case, place the speaker inside a TV rack
or on a level floor.
– Before attaching the fasteners to the TV, clean the
surface with a dry cloth. A dirty or wet surface may
weaken the adhesive force and cause the speaker to
fall.
– Do not touch the bonding surfaces of the fasteners
after peeling off the seals. Doing so may weaken
the adhensive force and cause the speaker to
fall.this installation. Use metric screw threads only.
Attaching to a wall
You can attach the speakers to a wall using commercially
available screws (Diameter: 3.5 to 4 mm, Length: 25 mm
or more). Each speaker requires two screws.
1 Install two screws in the wall where you want to place
the speaker.
2 Hang the speaker on the screws using the holes in the
back of the speaker.
– To attach a speaker to a wall using screws, the wall
must be firm. Do not attach a speaker to a wall that
is made of weak materials such as plaster or
veneered woods. Doing so may cause the speaker
to fall.
– When connectiong the speakers, fix the speaker
cables in place so that cables do not loosen. If your
foot or hand accidentally gets caught on a loose
speaker cable, the speaker may fall.
– After attaching each speaker, check that the
speaker is fixed securely. YAMAHA will bear no
reponsibility for any accidents caused by improper
installations.
Notes
Fastener
Peel off
the seal
NX-C301
Fastener
Peel off
the seal
NX-C302
Notes
+
–
5 mm
Screws (3.5
to 4 mm dia.,
commercially
available)
20 mm or more
110 mm
NX-C301
+
–
5 mm
Screws (3.5
to 4 mm dia.,
commercially
available)
20 mm or more
151 mm
NX-C302