Open as PDF
■ Setting a TV
Make sure you have completed all the necessary connections
(see “Connecting a TV” on page 19).
1 Press DVD/CD.
→ “DVD/CD” appears in the display panel.
2 Turn on the TV and set to the correct video-in channel.
→ You should see the background screen on the TV.
– Usually this channel is between the lowest and
highest channels and may be called FRONT, A/V IN
or VIDEO. See your TV manual for more details.
Or, you may go to channel 1 on your TV, then press
the Channel down button repeatedly until you see the
Video In channel.
Or, the TV remote control may have a button or
switch that chooses different video modes.
Selecting the TV type
In order for a DVD to play on this DVD receiver, the color
system of the DVD, the TV and the DVD receiver should
match. Before changing the TV system, determine the
color system of your TV.
1 In DVD/CD mode, press SET UP.
2 Press repeatedly to select [VIDEO SETUP PAGE].
3 Press / to highlight [TV TYPE], then press
4 Press / to highlight one of the options below:
PAL – Select this if the connected TV has the PAL
color system. It will change the video signal of an
NTSC disc and output it to PAL format.
NTSC – Select this if the connected TV has the NTSC
color system. It will change the video signal of a PAL
disc and output it to NTSC format.
MULTI – Select this if the connected TV is compatible
with both NTSC and PAL (multisystem). The output
format will be in accordance with the video signal of
5 Select a setting and press ENTER (OK).
– Follow the instructions shown on the TV to confirm
the selection (if any).
If a blank/distorted TV screen appears, wait for 15
seconds for auto recovery to activate.
When you are selecting color system by using the remote
control, follow the procedure below.
1 Open the disc tray.
2 Press , then press AUDIO.
→ If the default setting of the color system is NTSC,
it will be changed to PAL.
→ If the default setting of the color system is PAL, it
will be changed to NTSC.
VIDEO SETUP PAGE