Filter
Top Products
91 En
Advanced setup
ADVANCED
OPERATION
English
4 Press the numeric buttons (
F
) to enter the
four-digit remote control code for the input
area you want to use.
Remote control AMP ID codes
Select one of the following codes to set the remote control
AMP ID code for the input area you want to use.
5 Press
D
ENTER to set the number.
“OK” appears in the display window (
J
) if setting
was successful.
“NG” appears in the display window (
J
) if the
setting was unsuccessful. In this case, start over from
step 1.
6 Press
T
LEARN again to exit from the setup
mode.
■ SCENE IR code setting SCENE IR
Use this feature to output the remote control signals at the
REMOTE OUT jack automatically when this unit is in the
SCENE mode.
Choices: ON, OFF
• Select “ON” when the component connected to the
REMOTE OUT jack is the Yamaha component and has
the capability of the SCENE control signals. This unit
automatically sends the remote control signals to the
component.
• Select “OFF” when the component connected to the
REMOTE OUT jack is not the Yamaha component and
does not have the capability of the SCENE control
signals.
If noises are output when you operate the SCENE function, set
“SCENE IR” to “OFF”.
■ Bi-amplifier setting BI-AMP
Use this feature to activate or deactivate the bi-amplifier
function (see page 14).
Choices: ON, OFF
• Select “ON” if you want to activate the bi-amplifier
function. “SUR.B L/R SP” is set to “NONE”
automatically, and this unit outputs the front channel
audio signals at the SURROUND BACK speaker
terminals.
• Select “OFF” if you want to deactivate the bi-amplifier
function.
When “BI-AMP” is set to “ON”, you can only select “FRONT B”
or “NONE” in “EXTRA SP ASSIGN” (see page 64).
■ Video parameter reset V.RESET
Use this feature to initialize the “VIDEO CONV.”,
“HDMI UP-SCALING”, “HDMI ASP” and “OSD
SHIFT” settings in “DISPLAY SET” (see page 73).
Choices: YES, CANCEL
■ Monitor check MON.CHK
Use this feature to activate or deactivate the monitor check
function of this unit. When this parameter is set to “YES”,
this unit receives the information of the available video
signal resolutions from the video monitor connected via
HDMI (see page 73).
Choices: YES, SKIP
AMP ID code
(remote control
setting)
Function
Remote
control AMP
ID
2001
(initial setting)
To operate this unit using the
default code.
ID1
(initial setting)
2002 To operate this unit using an
alternative code.
ID2
4
3
2
0
9
5
1
7
6
8
STEREO
SUR. DECODE
NIGHT
CLASSICAL
LIVE/CLUB
ENTERTAIN
ENHANCER
MOVIE
LEARN
See page 89 for the operation of the advanced setup.
Note
Note