Filter
Top Products
41 En
Playback
BASIC
OPERATION
English
■ Audio information
“---” appears when this unit cannot display the corresponding
information.
■ Video information
“---” appears when this unit cannot display the corresponding
information.
Use this feature to automatically set this unit to the
standby mode after a certain amount of time. The sleep
timer is useful when you are going to sleep while this unit
is playing or recording a source. The sleep timer also
automatically turns off any external components
connected to AC OUTLET (see page 24).
Even if this unit is in the standby mode, this unit does not cut off
the power to AC OUTLET while charging connected iPod
(see page 23).
Set the operator mode to
L
AMP and then press
S
SLEEP repeatedly to set the amount of time.
Each time you press
S
SLEEP, the front panel display
changes as shown below.
The SLEEP indicator flashes while you are switching the
amount of time for the sleep timer. Once the sleep timer is
set, the SLEEP indicator lights up in the front panel
display, and the display returns to the selected sound field
program.
■ Canceling the sleep timer
Press
S
SLEEP on the remote control repeatedly
until “SLEEP OFF” appears in the front panel
display.
The SLEEP indicator turns off, and “SLEEP OFF”
disappears from the front panel display after a few
seconds.
y
The sleep timer setting can also be canceled by pressing
H
STANDBY (or
1
STANDBY/ON) to set this unit to the
standby mode.
FORMAT
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
SAMPLING
The number of samples per second taken from
a continuous signal to make a discrete signal.
CHANNEL
The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as “3/2/0.1”.
BITRATE
The number of bits passing a given point per
second.
FLAG
Flag data encoded in DTS, Dolby Digital, or
PCM signals that cue this unit to automatically
switch decoders.
Note
HDMI SIGNAL
Type of the source video signals and the
video signals output at the HDMI OUT
jack of this unit.
HDMI RES.
Resolution of the input signal (analog or
HDMI) and the output signal (HDMI).
When input video signals are composite
video or S-video signals, the input video
signals are indicated as “Composite” or
“S-Video”.
HDMI ERROR
Error message for HDMI sources or
connected HDMI devices. See page 96
for details.
Note
Using the sleep timer
Note
SLEEP 120min SLEEP 90min
SLEEP 60minSLEEP 30minSLEEP OFF
SLEEP
SLEEP120min
Flashes
SLEEP
STRAIGHT
Lights up
SLEEPOFF
Disappears