Filter
Top Products
25 En
Connections
PREPARATION
English
1 Make sure this unit is turned off.
Refer to the right column for details.
2 Press and hold
5
TONE CONTROL on the
front panel and then press
1
STANDBY/ON
to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the
6
PROGRAM selector on the
front panel to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8Ω MIN”) appear in the front panel display.
4 Press
5
TONE CONTROL on the front
panel repeatedly to select “6Ω MIN”.
5 Press
1
STANDBY/ON on the front panel to
save the new setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
■ Turning on this unit
Press
1
STANDBY/ON
on the front panel to
turn on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press
1
STANDBY/ON
(or
H
STANDBY
) to
set this unit to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
y
• You can also turn on this unit by pressing
3
SCENE (or
A
SCENE) buttons.
• When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
Note
TONE CONTROL
STANDBY
/ON
While holding
down
Turning this unit on and off